how to remove automate am1?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127209
Printed Date: May 17, 2025 at 6:42 PM
Topic: how to remove automate am1?
Posted By: ixlar8
Subject: how to remove automate am1?
Date Posted: May 03, 2011 at 8:32 AM
I bought a used Ford 500. It has an Automate AM1 installed under the dash. I do not have any remotes nor do I want to use this unit. Besides the Dome lamps stay on until the battery kill kicks in and the trunk dash switch and on the remote don't work. I have the install manual, but I am not sure what actions to take to restore this to normal.
adTHANXvance
ixlar8@gmail.com
Replies:
Posted By: blanx218
Date Posted: May 03, 2011 at 9:09 PM
Everything should be located under the drivers side dash. Find the brain of the AM1, follow every wire from it to where it connects to the car and disconnect it. Its gonna depend on who installed it to whether the connections are soldered or not. But most importantly make sure any bare wire is taped up well with some high quality electrical tape. 3M Tempflex 1700 or something similar.
|