Print Page | Close Window

06 dodge ram 2500 diesel

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127311
Printed Date: April 29, 2024 at 12:11 AM


Topic: 06 dodge ram 2500 diesel

Posted By: pitoaudiovisual
Subject: 06 dodge ram 2500 diesel
Date Posted: May 12, 2011 at 5:53 PM

I want to do a remote starter in a Dodge Ram 2500 and i was going to install a DB-All for the bypass part and a Prestige ASP620N and i noticed for the paper work for the diesel bulb wire there is nothing and it says i have to use Direct Fax number 1091 which shows another bypass called a 528T and not really sure how it works before i do the install cause this is the first Diesel ive done so if anyone know how to wire this car up with the wait to start and if i really do need the 528T let me know... Thanks in advance

-------------
Confidence is the key to any project!!



Replies:

Posted By: ac0j
Date Posted: May 13, 2011 at 9:45 PM

I am not a prestige dealer so I dont know about them, BUT most remote starts have a wait to start wire that would connect to the wait to start light.

OR it might have a wait to start timer in the RS programming.  Set it to 30 or 60 seconds depending on how long the cold diesel takes to get ready to start. Otherwise it is just like any other remote start install.   NOTE use tach mode, because voltage sense mode might cause problems in a diesel install because of the 2 batteries.




Posted By: i am an idiot
Date Posted: May 13, 2011 at 11:11 PM
Prestige does have a programmable delay.  I think the choices are 10, 15 and 20 seconds. 



Posted By: Mike M2
Date Posted: May 14, 2011 at 5:35 PM
Yep, no need to connect anything. Simply program diesel delay....

-------------
Mike M2
Tech Manager
CS Dealer Services



Posted By: syl20rochon
Date Posted: May 14, 2011 at 8:06 PM
Use the diesel timer and use the tach output of the DBALL and you'll be fine.

-------------
Sylvain Rochon
MECP security specialist
Tech support for remote starters
26 Years of experience counts
I'm here to help.


Print Page | Close Window