add tilt sensor to 2010 dodge ram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127356
Printed Date: September 12, 2025 at 1:50 AM

Topic: add tilt sensor to 2010 dodge ram

Posted By: jason510
Subject: add tilt sensor to 2010 dodge ram
Date Posted: May 16, 2011 at 6:10 PM

I have 2010 dodge ram coming in. They want to add a sensor to the bed cover and have it trigger the factory alarm.

I was thinking to use a DEI 507m digital tilt sensor. My questions are what wire going to the factory alarm can I tap into to add this extra trigger point, and if I use a 507M, what output can I use to trigger the sensor to "setup"

Thanks in advance!

Replies:

Posted By: blanx218
Date Posted: May 17, 2011 at 9:56 PM

Factory alarms really dont have any trigger inputs other than door triggers. I would connect the blue(-) instant trigger from the 507m to the door trigger purple(-) in the drivers door harness with a diode, orange (-) GWA to the pink/white ignition, & red to +12V constant

Print Page | Close Window