300 rattler, how to disable?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127407
Printed Date: June 04, 2024 at 7:04 PM

Topic: 300 rattler, how to disable?

Posted By: altapasacal
Subject: 300 rattler, how to disable?
Date Posted: May 20, 2011 at 7:34 PM

All, I am new to this. I have the 300 Rattler and it was installed some years ago. I have lost the remote to the rattler and the battery had died thus now after getting a jump the alarm sounds. Can you please give me advice on what to do. How do I easily disable because now my ignition or car will not start? is it easy to get another remote or can I disable the alarm? I know where the rattler black box is but I dont know which wires to pull? Or do I need to pull any wires?

-------------
altapasacal

Replies:

Posted By: kallan90
Date Posted: May 20, 2011 at 8:18 PM

To get your car to start, you will have to reconnect the wires as in the image below.
posted_image

I think you should be able to just disconnect all the connectors to the alarm module(black box) to stop the alarm from going off too.

Posted By: blanx218
Date Posted: May 20, 2011 at 10:21 PM

Near the brain should be an inline fuse on the red constant power wire. remove the fuse and its disabled and the car will start.

Posted By: howie ll
Date Posted: May 21, 2011 at 12:04 AM

Or just pull the plug on the unit

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.