viper 5701 into a 2010 jeep wrangler

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127448
Printed Date: May 10, 2025 at 4:54 AM

Topic: viper 5701 into a 2010 jeep wrangler

Posted By: theiss2200
Subject: viper 5701 into a 2010 jeep wrangler
Date Posted: May 25, 2011 at 3:08 PM

I haven't installed a remote start in a long time. I have a customer that wants me to install the Viper 5701 into a 2010 Jeep Wrangler, Stick shift, I was wondering if anyone has done this before or maybe knows where I can find and instalation instructions or diagrams for this vehicle and the remote start? Any sugestions on putting this in?
thanks

Replies:

Posted By: zeros
Date Posted: May 25, 2011 at 3:49 PM

i just did the same thing... use a CHALL and cth2 interface and it is pretty much plug and play... you shouldnt have any problems.. only have to wire up a few things..

Posted By: theiss2200
Date Posted: May 26, 2011 at 10:18 AM

where can I find the CHALL? Thanks for the info

Posted By: zeros
Date Posted: May 26, 2011 at 12:30 PM

no problem ... most audio places have them.. i got mine at caraudiogiants.com you will need a CHALL and cth2 cable.

Posted By: kbb2002
Date Posted: May 27, 2011 at 3:16 PM

I prefer the DB-ALL from xpresskit. I just installed a 5701 with a DB-ALL on a 2006 Chrysler 300 and it was a breeze. If you go to xpresskit.com it also has a wiring diagram. I also bought the XKLOADER2 so i could flash the DB-ALL with the latest Chrysler firmware.

Print Page | Close Window