2011 nitro, remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127516
Printed Date: May 09, 2024 at 9:56 AM

Topic: 2011 nitro, remote start

Posted By: qdaddy
Subject: 2011 nitro, remote start
Date Posted: June 01, 2011 at 12:15 PM

2011 nitro r/s viper 5901 and chall bypass. everything works fine easy install then customer brought back cuz not starting anymore. i unplug bypass and alarm plug back in and started wrkng fine cust left called back 2 hours later same thing. any ideas

thnx in advance

Replies:

Posted By: Mark Mizenko
Date Posted: June 02, 2011 at 10:30 AM

Is that TIPStart, or Regular fobkey?

Did you try calling DEI?

I would use a PKUMUX if it was reg fobkey.

Posted By: qdaddy
Date Posted: June 03, 2011 at 10:51 AM

reg remote on the key. was easy install plug n play. maybe needs software flash update? but if that is the case y does it work at all then?

thnx in advance

Posted By: Ravendarat
Date Posted: June 03, 2011 at 4:38 PM

I had this same issue on a Dodge heavy duty truck. Spent half a dozen appointments trying to track this down, pulled the brain antenna and remote and sent them to DEI to try to reproduce the issue and they couldnt, uninstalled everything, re wired in new harnesses and still no solution, switched the unit to a 5701 2 way LED and the problem went away. DEI said that there had to be something in the vehicle causing the issue but the truck was completely stock. At the end of the day I never found a solution, if you figure your problem out let me know.

-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer