Print Page | Close Window

2006 crown victoria, alarm/remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127604
Printed Date: June 09, 2024 at 3:40 AM


Topic: 2006 crown victoria, alarm/remote start

Posted By: AciDFluX
Subject: 2006 crown victoria, alarm/remote start
Date Posted: June 10, 2011 at 5:36 PM

I would like to install a remote start alarm this weekend in my 06 crown victoria police interceptor. I've been looking all over the net and this forum for a diagram of wires and locations but haven't found anything except for 05. Any assistance is greatly appreciated with this request.




Replies:

Posted By: i am an idiot
Date Posted: June 10, 2011 at 7:38 PM




Posted By: kreg357
Date Posted: June 10, 2011 at 8:33 PM
Looks like 2005 thru 2008 are the same.  Bulldog Security has it listed with pictures for the ignition switch release.  https://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp

-------------
Soldering is fun!




Posted By: howie ll
Date Posted: June 12, 2011 at 8:03 AM
Just loaded it to Downloads/Manuals section.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.




Posted By: AciDFluX
Date Posted: June 13, 2011 at 3:37 PM

I'm installing a viper remote start in my 06 Crown Vic. I noticed there are 2 accessory/blower wires from the factory. The viper unit I have only has 1 accessory wire and 2 ignition wires. Should I be safe wiring the 2 factory wires together to the 1 accessory wire on the relay satellite? Also what about the ABS wire that will make the ABS light flash unless you hook it up?

Thanks for any expertise that can be provided.






Print Page | Close Window