2011 nissan juke

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127856
Printed Date: April 20, 2024 at 6:08 AM

Topic: 2011 nissan juke

Posted By: XLR8
Subject: 2011 nissan juke
Date Posted: July 08, 2011 at 12:47 PM

Hello All,
Looking for a diagram for remote start of a Juke push to start. my Installer companion is down, and a few other sites that do have a diagram only have without P.T.S.
most of the connections are shown on the ADS diagram but not all

Thanks in advance

Replies:

Posted By: Mark Mizenko
Date Posted: July 12, 2011 at 10:08 AM

Whats missing on the ADS diagram? Parking lights... pass kick, or drivers kick. I think thats it, is'nt it.

A VERY easy vehicle to do.

Just be sure to run your (-) start wire out to the IPDM, triggering a relay, and dont forget to diode isolate that (-) input to the relay, or you get a funky chatter AFTER you turn the RS off.

Dont use voltage sensing for start on this vehicle. Get it from the ADS module or wire to tach/coil. The alternator doesnt turn on soon enuff on these vehicles.

Print Page | Close Window