asianwolf pw4 window module
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127938
Printed Date: May 16, 2025 at 12:19 AM
Topic: asianwolf pw4 window module
Posted By: bigab3
Subject: asianwolf pw4 window module
Date Posted: July 16, 2011 at 11:21 PM
This should have been an easy install but i am having trouble getting the trigger on my alarm to activate the window (autopage rf 320). If i manually put a wire on the alarm the window will roll up but, once I use one of the aux channels, nothing happens. Does anyone have any tips on what to do or how to troubleshoot this problem.
-------------
Bigab3
Replies:
Posted By: howie ll
Date Posted: July 17, 2011 at 12:26 AM
Maybe not enough current to trigger it, use a relay like this:-
Aux* to 85.
12v+ constant fused at 3 amps to 86.
GOOD ground to 87.
Window close trigger to 30.
Use a 1N4004 diode between 85 and 86 with its band towards 86
* Used a timed aux rather than an armed out to 85, set for a max of 10-15 seconds. If you use the GWA wire you will have a flat battery in six to eight hours because the relay is constantly energised.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|