led specs on the clifford 50.5x
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127990
Printed Date: May 20, 2024 at 9:21 PM
Topic: led specs on the clifford 50.5x
Posted By: o2civic
Subject: led specs on the clifford 50.5x
Date Posted: July 20, 2011 at 8:15 PM
I'm looking to upgrade my LED to something brighter. I have dark tints and can barely see the LED flash when the alarm is active.
Anyone have any suggestions that does not require modifying too much? Plug and play would be perfect.
Thanks!
-------------
o2civic
Replies:
Posted By: i am an idiot
Date Posted: July 20, 2011 at 8:30 PM
Do you have a volt meter? Is there a way to make the LED illuminate without flashing?
Posted By: howie ll
Date Posted: July 21, 2011 at 4:46 PM
it's a 2.5 volt LED as standard Mr.I and there's no plug and play replacement apart from the one used on Clifford G5 product which is brighter. alternatively go for a 10mm ultrabright with maybe a resistor.
Red is the cathode (+) and blue is the anode (-) neg.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: tonanzith
Date Posted: July 21, 2011 at 10:05 PM
A plug and play replacement no, but there are 2 watt ultra bright LED's that can be added on using the orange ground when armed wire of the 50.5x.
-------------
Gary Sather
|