door actuators to viper 1002
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128037
Printed Date: July 06, 2025 at 1:32 PM
Topic: door actuators to viper 1002
Posted By: shiba
Subject: door actuators to viper 1002
Date Posted: July 25, 2011 at 9:59 PM
Ok, please be kind. Im a newb here. I have installed several stereo systems before, but this is my first time dealing with an alarm.
I have done some research and I have gotten conflicting info, I figured I would come here to get a definite answer. I have an 01 Tacoma 2WD base model. No power locks or power windows. It has a Viper 1002 installed with horn honk, glass break sensor and a hood pin. I would like to ad power locks to my truck, I dont want any switches in the truck, I just want the doors to lock/unlock with my arm/disarm button on my Viper 1002 key fob. I have the 1002 Installation instructions and on page 9 it says, "This system has door lock relays on-board, and can directly interface with most electric power door lock systems drawing 30 amps or less". Does this mean I can just run wires directly from the alarm to the actautors? Or do I need to wire in two relays as stated in the relay tech section?
Thanks for any help.
Replies:
Posted By: Twelvoltz
Date Posted: July 25, 2011 at 10:39 PM
Yes, you are correct you don't need any additional relays. Wire up the door locks using "Aftermarket actuators, diagram D" on page 12 of the manual.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: shiba
Date Posted: July 26, 2011 at 1:36 AM
Twelvoltz wrote:
Yes, you are correct you don't need any additional relays. Wire up the door locks using "Aftermarket actuators, diagram D" on page 12 of the manual.
Great thanks, but I have some questions about the diagram D.
1) On the lock/unlock normally open (input) the diagram says I need to have a 12 volt positive input, do I tap off from a 12 volt battery source for this?
2) Lock #30 common, and Unlock #30 (output) has it going to the green and blue of the actuator motor. Do I run these connections to both actuators individually?
Posted By: howie ll
Date Posted: July 26, 2011 at 3:46 PM
Yes or a heavy 12V+ constant input (i.e. from the battery) supply to your fuse box.
Split the green and blue and run each blue and green to each motor blue and green.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: shiba
Date Posted: July 26, 2011 at 9:26 PM
Thanks everyone, I really appreciate the help. Looks as if Ill be ordering a door actuator kit when I get paid next month.
|