python 592 multiple sensor reporting
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128056
Printed Date: May 15, 2025 at 6:24 PM
Topic: python 592 multiple sensor reporting
Posted By: bantham1
Subject: python 592 multiple sensor reporting
Date Posted: July 26, 2011 at 10:15 PM
I have a python 592 with a tilt and glass break sensor. Is there a way to program both sensors to report as "tilt" and "glass break." There is only 1 aux input on the brain so how does the alarm distinguish between both sensors? right now the glass break is reporting correctly as "glass break" but the tilt is reporting as "trunk trigger."
Replies:
Posted By: itsyuk
Date Posted: July 27, 2011 at 4:19 AM
if the alarm has only one zone, that all there is ....BUT...
you could diode isolate each input on the wire and use multiple 795T (non- vibrating) or 795W (vibrating)pager system to tell you which item is triggering. these old pager systems are cool, the pager could pick up 3 different channels from the transmitter that came with it and could also pick up other optional transmitters from 2 other cars ....
or.. you could install 1, 2, or 3 transmitters on a single car and have the pager monitor them all at the same time.
on my upcoming roadmaster wagon install i am using 2 transmitters and can seperately monitor doors, front radar, rear radar, rear gate, hood, and 520t all at once. the doors are the only one not on the single blue mpx wire. its best to tie all warn-away wires to the shock sensor input.
if a1, a2 or a3 light up on the pager, i know the vehicle has had a door, rear gate or hood breeched.
if b1, b2 or b3 light up, its one of the 3 sensors i mentioned.
just something to think about.
-------------
yuk
quiet rural missouri, near KC.
If your system moves you physically and not emotionally, you have wasted your money.
Posted By: bantham1
Date Posted: July 27, 2011 at 7:38 AM
You could do that but that sounds like a lot of pagers. I have the full HD remote and saw in the demo all those cool animations for each trigger zone but I can only use the glass break. You think they would have put more sensor inputs in the brain to accommodate more sensors to report correctly
Posted By: itsyuk
Date Posted: July 27, 2011 at 1:43 PM
no a single pager can monitor 3 different transmitters(broadcasting 3 channels) giving up to 9 discreet channels.
you only carry one pager and
a1,a2,a3 is one tranmitters channels
b1, b2, b3 is another
and c1, c2, c3 are yet another ------------- yuk
quiet rural missouri, near KC.
If your system moves you physically and not emotionally, you have wasted your money.
|