remote start take over is not working

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128119
Printed Date: May 04, 2024 at 8:07 AM

Topic: remote start take over is not working

Posted By: coco_ae
Subject: remote start take over is not working
Date Posted: August 02, 2011 at 3:48 PM

Hi all

Car: Infiniti M56 2011

remote start: compustar FT-6200S-CONT

bypass: Datalink ads-al ca

the car will remote start without any problem but the issue when i enter my car and press the brake it shuts down and the ignition turns to "On"... i press the button to get it back to off and start the car and this error comes to the screen. posted_image

Replies:

Posted By: racing_bidule
Date Posted: August 02, 2011 at 8:51 PM

Hi, this seems like you connected your (+) Brake pedal input from the compustar to the vehicle.

If you want the ADS module to handle take over for you, you must make sure you use Data brake pedal status not hardwired. Using data brake pedal status will delay the brake status output after the push button pulses are sent. Right now your remote starter receives the brake status before the pulses are sent.

-------------
If you fail on your first attempt, at least destroy all evidence you tried!

Posted By: coco_ae
Date Posted: August 04, 2011 at 1:56 AM

i have connect the brake input to the ADS.

if i change to manuale take over whould it fix the issue for me?

and what about the error ? i'm afraid it will make an issue to to the system in the future.

Print Page | Close Window