Good evening everyone,
I just purchased a two way Performance Teknique 2 way car alarm ICBM-7071, and I am about to attempt to install it. I am somehow familiar with electronics and this forum has provided a wealth of knowledge over these years. I searched for a tutorial to install this alarm, but I did not have any luck. Can anyone provide a step by step as to how install the alarm? For instance, I do know how to take apart the ignition switch and test wires for voltage. From there, I am lost since I do not know where is the 99 jeep cherokee factory door module, or if the door locks are negative or positive triggered (how do i test for this?), vacuum type, reverse polarity, etc? I know that I am asking for too much, and that this alarm is very cheap, but is all I could afford now. All the help is greatly appreciated.
I attempted to install a starter kill switch, but after reading here, I am not sure if I need a relay with a diode or not. I was trying to put the switch inline with the brown small gauge wire that goes to the starter (I believe it comes from the ignition). But I did not know if a relay is needed. Please help.
I posted a link to the diagrams, and that is all it came with the alarm. As you can see it is pretty generic and useless for the noobs like me.
https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0003.jpg
[IMG]https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0001.jpg[/IMG]
https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0004.jpg
[IMG]https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0004.jpg[/IMG]
https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0001.jpg
[IMG]https://i1208.photobucket.com/albums/cc365/beautifulbella2011/Car%20Alarm/scan0003.jpg[/IMG]
Very respectully,
Joe
Please...Can someone help me? I would like to do the installation on my own. At least can someone provide enough information to get started?
Thank you,
Joe
|
All Door Trigger |
|
YELLOW |
|
(-) |
|
IN HARNESS IN DRIVERS KICKPANEL |
|
|
|
Trunk Trigger |
|
TAN/BLACK |
|
(-) |
|
AT LIGHT IN TRUNK |
|
|
|
Parking Lights |
|
BLACK / YELLOW |
|
(+) |
|
AT VEHICLE LIGHT SWITCH |
|
Power Unlock |
|
PINK/VIOLET |
|
(-) |
|
IN HARNESS IN DRIVERS KICKPANEL |
|
|
|
PowerLock |
|
ORANGE / VIOLET |
|
(-) |
|
IN HARNESS IN DRIVERS KICKPANEL |
|
Trnk Release |
|
PINK/BLACK |
|
(+) |
|
IN HARNESS IN DRIVERS KICKPANEL |
|
|
I hope this helps some
-------------
BAD Boy Emergency Vehicle Lighting
Thanks a lot. I will start working tomorrow on this project. I am kind of nervous because it will be my first alarm install.
Thanks for the help!