I was wondering I installed a Crimestopper CS 2011 RS in my wife's Blazer last week and now the turn/hazard relay clicks all the time when the ignition is on HELP please if anyone knows what is going on THanks
Did you tap the parking light wire into the hazard light wire by chance ? Try to disconnect the power going to the CS2011 and see if the problem persists. Try to isolate the problem by hooking up the harnesses one at a time until you can get the problem to occur. Post your results.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
double check your hook ups.
this might help you..
Constant 12 volts RED (2) IGNITION SWITCH HARNESS
Ignition 12 volts PINK IGNITION SWITCH HARNESS
Starter YELLOW IGNITION SWITCH HARNESS
Dome Light WHITE (-) AT BODY RELAY BLOCK *
Trunk Pin Switch PINK/BLACK (-) AT BCM BEHIND PASS DASH ON HEATER COR
Parking Lamp L BLUE (+) AT HEADLIGHT SWITCH
Power Lock L BLUE AT RELAYS IN #202
Power Unlock WHITE DRIVER KICK
* Body Relay Block Is Located Above Driver Kick Panel Area Near Fuse Block. Alternitive Door Trigger:TAN (-) Covers Driver Door Only. ORANGE (-) Covers Passenger Front Door. D BLUE/WHITE (-) Covers All Other Doors. Diode Isolation Needed, Cathode (Band) Side Of Diode Faces OEM Wires. Wires Located At BCM Behind Passenger Dash On Heater Core. #202- See Positive Pulse Door Lock Diagram.
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt