Print Page | Close Window

ignition wire / door trigger

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128291
Printed Date: March 28, 2024 at 7:08 PM


Topic: ignition wire / door trigger

Posted By: mleaser
Subject: ignition wire / door trigger
Date Posted: August 19, 2011 at 2:29 PM

Hello, I have a 2007 Ford F150 that is setup with the ignition wire does not turn off with the key, but turns off when you take out the key and open either driver or passenger door. I have the Viper 5701 and with those remotes you can easily hit a button to start the vehicle... Problem is when I accidently hit the Remote start and hit the button again to turn it off, it will turn off the vehicle but will leave the stereo and accessory's on until I actually go out to the truck and open a door and shut it. How can I make the ignition wires turn off without a door trigger? I don't really want to modify anything on the vehicle, but add something or program something on the alarm. thanks!



Replies:

Posted By: mleaser
Date Posted: August 19, 2011 at 2:59 PM

Not to confuse anyone, i meant the ignition wire being 12v Switched





Posted By: Mike M2
Date Posted: August 20, 2011 at 7:58 AM
You need to use the factory rearm wire on the Viper to pulse the drivers door trigger wire. This will shut it off, or you could just leave it alone as the radio will shut itself off after 10 minutes.

-------------
Mike M2
Tech Manager
CS Dealer Services




Posted By: mleaser
Date Posted: August 20, 2011 at 10:24 PM
Thanks! i will hook that up tomorrow and see if it works out. I hope that I still have my auxiliary harness.. Never had a use for it.





Print Page | Close Window