On/Start Remote OF-3000E

Recently bought an old van with an on/start remote in it. was able to purchase a new key fob but have no idea how to program them. Anyone have a manual detailing this?

ill post a link to the user manual when i have it uploaded in case anyone needs it.

This from Todd at Autostarts and more.:

Hi, took a couple days to find the manual, to program new remote
1. with engine off and key in off position, OPEN HOOD
2. within 20 seconds of opening the hood, turn ignition on and then off 4 times slowly, parking lights should turn on.
3. press button 1 on remote, the paring lights should go out if remote was programmed.
4. close hood.
5. to exit press button 1 again and parking lights
will flash twice. if it doesnt work check the hood pin switch, sometimes they
get rusty and wont make connection, if hood pin is shot then just ground the
wire that goes to the pin switch to metal for programming the remote the
unground when done.

On/Start OF-3000E User Manual

Transmitter Functions:
1 time = red
2 times = green
then press 1 or 2 to transmit a function

To start or stop the vehicle:
press button 2,
the parking lights flash 3 times and the vehicle starts
press 2 again to stop the vehicle (runs for 13 or 26 minutes)
enter the vehicle without touching the brakes and turn key to on position and drive the vehicle normally

To start with Horn:
press both button simultaneously
then press button 2
the vehicle will honk once and start, then honk again when it’s running

Continuous Mode:
Press button 2 while vehicle is running
parking lights come on and doors will unlock (optional)
remove the key and vehicle will continue to run for 20 minutes

Main switch Located in vehicle will disable the remote unit

Low Temperature Sensor:
Press both buttons
then press 1
prkg lights flash 4 times
if the cold weather start is activated the vehicle will start at -5 C or -15 C (it’s Canadian), and will start again after 3 hours if it’s still cold out.

Lock and Unlock Doors:
button 1 to lock
button 1 again to unlock

Safety Lock: Makes sure the doors are locked)
press both buttons simultaneously twice
press button 2
the doors will lock and the parking lights will flash once

Ignition Lock: (if programmed)
the starter will automatically lock the doors when the driver turns the key to on and presses the brakes.
will unlock the doors when the key is turned to off

Trunk Release: (Optional)
press both buttons simultaneously once
press button 1

Starter Disable : (optional in programming)
to prevent the vehicle from being started even with a key.
You have to use the Key Fob to unlock the doors to start and run the vehicle.