basic wiring remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128469
Printed Date: May 16, 2025 at 6:47 PM
Topic: basic wiring remote start
Posted By: sape33
Subject: basic wiring remote start
Date Posted: September 08, 2011 at 12:11 PM
Ignition wire. If I use a DMM When should I have 12V on my Ignition wire?
Only on Run and Start position?
Accesory wire on ingnition switch. If I use a DMM When should I have 12V(+) on my accesory wire?
On run and start position?
How can know the diference of Igniton wire and accesoty wire?
Does acc. wire interrupts at start position then go back to 12V(+)?
Starter wire. If using a DMM should I have 12V(+) only while starting car?
-------------
ok let't start. (+) is positive (-) is negative.
Replies:
Posted By: buddholly
Date Posted: September 08, 2011 at 1:12 PM
Acc will normally drop to 0 volts while turning the key over.
Ignition will normally drop to 10 volts or so while turning the key over.
Starter will only show 12 volts while turning the key then drop out to 0 volts while car is running.
-------------
|