errors in viper 5902 manual?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128506
Printed Date: May 05, 2024 at 11:50 AM

Topic: errors in viper 5902 manual?

Posted By: roger555
Subject: errors in viper 5902 manual?
Date Posted: September 12, 2011 at 7:23 PM

In the download section "Viper 5902 Installation Guide" Uploaded by Howie just last month.

In the programming guide Page 17 it lists the Status 2 Output as the "Dark blue H2/10 wire"

As far as I can tell the H2/10 is just the "Status Output" wire & the the "status 2 wire" is the (Blue/White H2/16)

Am I missing something here?

posted_image

Replies:

Posted By: smokeman1
Date Posted: September 12, 2011 at 7:55 PM

It wouldn't be the first time a Manual was not proof read enough and didn't have mistakes in it. After all, their Quality Control is the Customer! But I believe you ae correct.

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Posted By: kreg357
Date Posted: September 12, 2011 at 7:57 PM

Nope, you are correct , it is a typo. It is wrong in the newer 5701 Install guide, too.

H2/10 Dark Blue is (-) Status Output is Status Out only. . AKA Ground Out While Running, GWR, etc.

H2/16 Blue/White < size=1 face=Futura-Book>< size=1 face=Futura-Book>(-) 200mA 2ND STATUS /REAR DEFOGGER OUTPUT is a programmable output. Default is a basic GWR signal just like H2/10. Menu 3, Item 11 controls this wire.

Remember these Vipers manuals are written for the factory trained DEI installation tech......

-------------
Soldering is fun!

Posted By: roger555
Date Posted: September 12, 2011 at 8:08 PM

Cool I just wanted to confirm I knew it couldn't be right , thanks!