2011 toyota highlander immobilizer
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128554
Printed Date: May 12, 2025 at 9:26 PM
Topic: 2011 toyota highlander immobilizer
Posted By: Johnnynguyen20
Subject: 2011 toyota highlander immobilizer
Date Posted: September 18, 2011 at 11:15 AM
hello, i'm on the process of installing a Viper 5901 with Expresskit DB-ALL module firmware 401.TL4 v1.08. On the 2011 TOYOTA HIGHLANDER 4 CYLINDER
i have problem finding the IMI/IMO immobilizer wires. The installation of the db-all module show that 2011 Toyota Highlander 4 CYL IMI wire is Blue 31 pin, and IMO wire is Violet 32 pin, at At ECM, behind glove box, white 36-pin
(2nd from top), conn. D60
as i look at the 2nd plug from the top of the ECM the 31 pin is Blue and 32 pin also blue. can someone please help.
-------------
Johnnynguyen
Replies:
Posted By: kreg357
Date Posted: September 18, 2011 at 12:53 PM
Here is a link to the Fortin EVO-ALL Install Guide for the 2011 Highlander : https://ifar.ca/en/download/2919/preview.html They list the wires as Light Blue and Violet at those locations and include a diagram of the connector. Also verify your key has a "G" stamped on it for 80 bit encryption. ------------- Soldering is fun!
Posted By: Johnnynguyen20
Date Posted: September 18, 2011 at 1:37 PM
this 2011 Toyota Highlander Keys does not have the "G" stamped on, and doesn't have the Dot stamped on it either. The DB-ALL module does show the IMI, IMO connector and pin layout, i'm sure that i got the connector right, i have recheck and look for it 100 of time, still don't know with pin its go, there is like 2 violet wires, and few light blue wires on the connector.
-------------
Johnnynguyen
Posted By: Mike M2
Date Posted: September 19, 2011 at 6:23 AM
If it's not an SE model it doesn't have an immobilizer at all. Look for a transponder ring around the ignition key....
-------------
Mike M2
Tech Manager
CS Dealer Services
Posted By: chrisf88
Date Posted: September 20, 2011 at 4:04 PM
If it doesn't have the G stamped on it, it's a 40bit key. You do not need IMI and IMO wires, but RX and TX wires near the ignition switch.
-------------
Radio d'Auto Mobile Inc. Installer
Québec, Qc, Canada
|