viper 5301 v.s 2007 rav4 with keyless go
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128744
Printed Date: May 15, 2025 at 12:02 AM
Topic: viper 5301 v.s 2007 rav4 with keyless go
Posted By: alextz
Subject: viper 5301 v.s 2007 rav4 with keyless go
Date Posted: October 06, 2011 at 12:57 PM
Hello All,
I own a 2007 RAV4 and after searching over the Internet I decided to buy a Viper 5301 remote start system and a PK-05 as key bypass module.
I bought them both from the Internet and the dealer also sent me a detailed install manual including pictures and wire diagrams (very similar with diagrams found on this site).
Unfortunately my car seems not to respect these diagrams and this is happening be cause my car does not have a classical key ignition system but has a Start/Stop button, so I am unable to find the ignition harness.
I was unable to find any diagram for this kind of ignition system. Can anybody help me please?
Vehicle information:
Build date: November 2007
Model: RAV4 - 4WD Luxury (this model is commercialized by Toyota in Europe)
Engine: 2.0 VVt-i
Tramsmition: manual.
Here is a picture of the dash:
*You can see the start button.Please ignore the red squares.
Here are the connectors under the steering-wheel:
At the bottom of the IMAGE there is another connector (not fully included in the picture) but wires colors are not corresponding with install diagrams for ignition harness.
And here is the start button connector
Thank you,
Alex
I own a 2007 RAV4 and after searching over the Internet I decided to buy a Viper 5301 remote start system and a PK-05 as key bypass module.
I bought them both from the Internet and the dealer also sent me a detailed install manual including pictures and wire diagrams (very similar with diagrams found on this site).
Unfortunately my car seems not to respect these diagrams and this is happening be cause my car does not have a classical key ignition system but has a Start/Stop button, so I am unable to find the ignition harness.
I was unable to find any diagram for this kind of ignition system. Can anybody help me please?
Vehicle information:
Build date: November 2007
Model: RAV4 - 4WD Luxury (this model is commercialized by Toyota in Europe)
Engine: 2.0 VVt-i
Tramsmition: manual.
Here is a picture of the dash:
*You can see the start button.Please ignore the red squares.
Here are the connectors under the steering-wheel:
At the bottom of the IMAGE there is another connector (not fully included in the picture) but wires colors are not corresponding with install diagrams for ignition harness.
And here is the start button connector
Thank you,
Alex
Replies:
Posted By: alextz
Date Posted: October 10, 2011 at 8:05 AM
Posted By: Mike M2
Date Posted: October 11, 2011 at 6:36 AM