viper alarm /remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128898
Printed Date: May 15, 2025 at 11:53 AM

Topic: viper alarm /remote start

Posted By: mbalenhle
Subject: viper alarm /remote start
Date Posted: October 17, 2011 at 8:26 PM

HI.

I need help please, i have car alarm python 323 model (viper 3202) , and a car remote start python model 1401(viper 5101) all connected to a chevy cruze, 2011 model , my problem is i can not get them to work together ,i have a problem with bypassing the python alarm system when its armed,when i remote start the car the alarm goes off, i have tried connecting the status output wire from the remote start to the H1/7 blue wire main harness 12 pin connector of the alarm system as they suggest in order to bypass some alarm zones but no luck, the alarm sysem is connected thru a D-ball all bypass system which strangely have taken over the vehicle antitheft system i can arm and disarm the factory system with python remote .

Any suggestions will do thanks.

-------------
mba222

Replies:

Posted By: smokeman1
Date Posted: October 17, 2011 at 9:03 PM

Mine thought would be take them out and put in a Python 872, (Viper 5701).

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Posted By: KPierson
Date Posted: October 18, 2011 at 2:59 PM

What is triggering the alarm? Is it the ignition input, the door pin, the trunk pin, or the shock sensor (or another sensor installed)?

I would guess it's the ignition signal - if it is you may need to diode isolate that signal from the remote start output so that the alarm never sees the ignition voltage provided by the remote start.

-------------
Kevin Pierson