cruze fortin evo all programmin

Hi guys,

This is my first post. I have a (European) Cruze. I wanted to install a keyless go and push to start system form advancedkeys (AK 103). They told me I need a bypass kit. So far so good. I tried to connect the proper wires (Hardware Vers 3.0 Firmware 3.10) and programm it. There is a part in the manual that has to be completed in less than 5 sec and here the problem starts. It says turn to run position (start the car ?!?) and wait for red led to flash once. The red light goes off and comes back on solid. Turn off and on again => the red led flashes 3 times and comes back on solid instead of the yellow led flashing 10 times. So I am stuck. All the wires are connected properly. Although I did not connect the keyless system yet. I wanted to program the evo first.

Thanks for your help, I am fresh out f ideas!

Cheers

Michael

I have the same problem, programming procedure are different US and European GM cars. but nobody knows how to make programming of european cars, exept russian fortin, but they keep it in a secret.