03 sequoia and rs avital 4103
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129275
Printed Date: May 14, 2025 at 1:19 AM
Topic: 03 sequoia and rs avital 4103
Posted By: wyciwug
Subject: 03 sequoia and rs avital 4103
Date Posted: November 18, 2011 at 8:21 AM
Would like to disarm factory during remote start using the Avital 4103 but doors will still be locked. Please help me with the wirings, thanks. This is where I get confused most. ------------- DCD
Replies:
Posted By: jseibold
Date Posted: November 18, 2011 at 8:53 AM
I don't have the schematic for your Avital, but it should have a "ground output while remote started" wire. Connect this wire to the key sense wire in the Sequoia. The factory alarm will disarm but the vehicle will remain locked.
Audiovox tech notes say Key sense wire is: YELLOW /GREEN wire-negative-found in the ignition harness in a 2 pin connector.
Audiovox note: IF YOU USE THE DISARM OUTPUT FROM THE ALARM IT WILL DISARM THE FACTORY ALARM IF YOU USE THE 3RD IGNITION (-) OUTPUT ON THIS WIRE IT WILL DISARM THE FACTORY ALARM UPON REMOTE START -------------
Posted By: wyciwug
Date Posted: November 18, 2011 at 9:29 AM
Hello
I do not see that on Avital 4103. Can I use 4-pin Sat harness: blue wire: status output to connect this to keysense wire? Thanks
This is the diagram: https://www.directeddealers.com/manuals/IG/Avital/N4103_2008-07_web.pdf
Thanks a ton!!! ------------- DCD
Posted By: chev104275
Date Posted: November 18, 2011 at 9:41 AM
The blue status output is what you want to uae same as ground when running wire just different name
-------------
If i Can't Install it I Don't need it Joe
Posted By: Chris Luongo
Date Posted: November 19, 2011 at 6:43 AM
Yes....
Avital small blue to car's keysense wire at ignition switch.
Avital small blue/white to ground-when-running input on bypass module.
What are you using for bypass?
Posted By: wyciwug
Date Posted: November 19, 2011 at 7:51 AM
hello
I am using flashlogic by pass. I use XK01 for door modules to unlock/lock doors. Thanks ------------- DCD
Posted By: Mike M2
Date Posted: November 19, 2011 at 11:34 AM
Following the instructions for the Flashlogic install will disarm the factory alarm...
-------------
Mike M2
Tech Manager
CS Dealer Services
Posted By: wyciwug
Date Posted: November 20, 2011 at 1:12 PM
Hello
I got the RS4103 hooked up. I have question about hooking up the FlashLogic FLC-AT. Had it flashed for used with 2003 Toyota Sequoia
I figured this is type 1 installation. I want to use DBI port to connect to the RS. However, Do i still use other wires as well? Such as WHITE/ black, WHITE/ red, orange-amp, pink/black, Pink, Blue/Red, GREEN/ Red, Gray/Red. I know that if I used DBI, i do not need to use Blue/white, Black, and 12V Red wires.
And it said 1x Diode required? Where would I use that in?
D
|