crime stopper sp 600

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129342
Printed Date: July 12, 2025 at 3:17 PM

Topic: crime stopper sp 600

Posted By: deeryders
Subject: crime stopper sp 600
Date Posted: November 22, 2011 at 7:05 PM

I just got a Crime Stoppers SP-600 going into a 2009 Civic with a Flash Logic FLCAN bypass .. i was wonder since i am not able to use the D2D port I have to hard wire it. I am trying to find out what wire on the SP-600 do i connect to the blue wire on the FLCAN. I would figure its the ground when running wire but i didnt see anything in the manuel that showed this wire. I am very familiar with DEI remote starts and alarms but never did a Crime Stoppers alarm. I see there is 4 pin connector thats goes into the sensor port with a red black green and clue wire. Are one of these the ground when running wire that i need. Thank you guys a million.

Replies:

Posted By: kreg357
Date Posted: November 22, 2011 at 7:26 PM

Can't find the manual for the SP-600 but the SP-500 has a programmable Blue/Black wire called (-) Ignition that should work if you are going to the FLCAN Blue/White GWR wire.

-------------
Soldering is fun!

Posted By: deeryders
Date Posted: November 22, 2011 at 9:34 PM

yup its here blue/black its called ignition run ... negative output .. so this the ground when running wire i need? thanks alot .. your a life saver