2008 sebring sedan starter wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129447
Printed Date: April 27, 2024 at 9:57 PM

Topic: 2008 sebring sedan starter wire

Posted By: mathondaman
Subject: 2008 sebring sedan starter wire
Date Posted: November 29, 2011 at 9:36 PM

I need help. I cannot locate the starter wire to install a gps locater and starter interrupet on a 2008 sebring sedan.

in the diagram it shows starter 1 yellow/violet at module on drivers fender under hood (not for remote start)

Any direction would be a big

Replies:

Posted By: jseibold
Date Posted: November 30, 2011 at 1:32 PM

Are you installing a GPS tracking unit that has an output to "cut off" the starter circuit (using a relay)? If so then the wire you mentioned in your post is the correct one. That particular wire is not necessary to interface when doing remote start, but interrupting that wire as you plan to do will not let the vehicle start. I would set things up to have the relay inside of the car instead of under the hood.

-------------

Posted By: mathondaman
Date Posted: December 01, 2011 at 12:11 AM

yep got it thanks for the reply. are you suggesting the relay to keep out any interference the interupt might cause

Posted By: jseibold
Date Posted: December 01, 2011 at 11:00 AM

I am assuming that your GPS unit has a negative output when enabled so I took it for granted that you would be using a relay. If your GPS unit has a built in starter interrupt circuit and 2 wires looping out of it you won't need a relay. If you do need to use a relay there is a diagram available on this site for starter interrupt using an alarm. Simply substitute your GPS negative output for the diagram's alarm negative output (when armed).

-------------

Print Page | Close Window