led indicating tubo timer mode
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129585
Printed Date: November 03, 2025 at 6:55 PM
Topic: led indicating tubo timer mode
Posted By: offroadzj
Subject: led indicating tubo timer mode
Date Posted: December 08, 2011 at 6:22 AM
I finally got around to connecting my WHITE/ blue activation input into a factory momentary switch (rewired for ground signal) so I can activate the turbo timer built into my Python 991. Is there someway to connect an LED to the system that will indicate that the system is in turbo timer mode? Right now it doesn't seem like the remote is responding to the signal sent from the button so I have no way of knowing if it took the signal or not.. other than turning the ignition off and seeing if it stays running (which so far has worked just about every time). The LED would be a nice easy indication....
I was thinking possibly something with the GWR wire but can I connect the LED directly to the wire and other side to ignition or will I need a relay? Or is there another way of connecting an LED???
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
Replies:
Posted By: howie ll
Date Posted: December 08, 2011 at 9:41 AM
12v diode or any voltage diode with the relevant resistor, ground side to WHITE/ blue, 12v+ to constant 12v+ or ignition+.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|