clifford intellistart 4 issue

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129733
Printed Date: May 14, 2024 at 11:38 PM

Topic: clifford intellistart 4 issue

Posted By: mitchfa
Subject: clifford intellistart 4 issue
Date Posted: December 17, 2011 at 2:56 PM

Hello all

My intellistart works great for the most part. My only question is when I have the car started and want to leave it running I press the button and the starter engauges and grinds. I have re-set the tach but that does not seem to help. Is this part of the voltage setting? If so what should the voltage be set at?

99 GMC Suburban

Thanks

Replies:

Posted By: howie ll
Date Posted: December 17, 2011 at 5:40 PM

Intellistart only works with tach, there was a second "engineering" method but tach is used on 99% of installs. If the original installer didn't use tach, they were doing something wrong.
More likely no anti-grind installed.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Print Page | Close Window