Print Page | Close Window

2006 nissan altima xk09 issues

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129734
Printed Date: April 29, 2024 at 11:14 AM


Topic: 2006 nissan altima xk09 issues

Posted By: 97f150ext
Subject: 2006 nissan altima xk09 issues
Date Posted: December 17, 2011 at 4:55 PM

06 Nissan Altima.  Just re flashed the XK09 to NISS2_1.05.  Hooked it up, LED came on solid, flashed once and went out with ignition.  However, hit the remote start and I get 1 second of crank and the engine will not start.  If during the remote start process, I hold the head of the key to the ignition tumbler, I get full crank and start.  So I know its the programming in the XK09.  I've reset it a couple times and attempted to re-program, but I still have the same results.  Currently the CAN high and low wires are connected at the OBDII connector.  Would it change anything to hook them to the same wires at the BCM?  Not a problem to do, but I didn't have time to check before I had to go to a wedding this afternoon.  I have another XK09 I can flash and attempt to program if needed.  Any tips would be greatly appreciated.  Thanks.




Replies:

Posted By: shortcircuit161
Date Posted: January 14, 2012 at 9:47 PM
As long as you connected to the Blue (CAN High) and Pink (CAN Low) wires in the right order at the OBD connector, you shouldn't have to go to the BCM.

I would try resetting the module and then reprogram it again.

Make sure your connections for the CAN wires are soldered on.

Since you have another module, if your reprogramming doesn't work, I would change it out. Good Luck!




Print Page | Close Window