prestige aps901c remote starter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129804
Printed Date: May 09, 2024 at 7:34 PM
Topic: prestige aps901c remote starter
Posted By: oleg4
Subject: prestige aps901c remote starter
Date Posted: December 22, 2011 at 12:28 AM
i am putting a remote car starter on 2003 Toyota Camry 2.4l 4 cylinder and i got to point were i have to by bypass ANTI-THEFT SYSTEM its
TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM
the remote car starter has two black and red wires for TRANSPONDER by-pass port
and i have no idea how and where to connect thous wires
do i need buy a separate module for it or theirs a way to do it with out it, please help
Replies:
Posted By: howie ll
Date Posted: December 22, 2011 at 12:33 AM
Yes. Contact Audivox/Prestige, or idatalink, or Fortin.
I just checked with A/vox, Flash Logic FL CAN.
Also don't forget to ground (from the R/S GWR or status output wire) the car's keysense wire.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: dasbogie
Date Posted: December 22, 2011 at 12:58 AM
Are you certain your car has the immobilizer?
-------------
Advanced
Posted By: flobee4
Date Posted: December 22, 2011 at 7:16 AM
I just did a 2003 Camry 4 Cylinder, and it had no transponder. Its easy to see if it has one, there would be a "security" light on the same panel as the heating controls. It would be on that panel to the right. Usually only the 6 cylinder motors, or the XLE trim have a transponder. If the security light isn't there, then there is no transponder. Here is a picture of the security light, it would be in the same location for digital heating controls or manual.
Posted By: lectricguy
Date Posted: December 22, 2011 at 8:38 AM
If you have a transponder, you will need some form of transponder bypass for remote starting (refer to Hot Topics section for immobilizer bypass overview). The APS901C has 2 short leads (red and black) on a yellow plug--this is a transponder bypass control harness and is intended to connect to your bypass. The red provides constant +12V to power the bypass, and the black is programmable, but is defaulted as active (Ground out) while the remote start is active/running. These leads don't go directly to the car; you would wire the red to the constant power input of the bypass, and the black as the GWR (Ground While Running) input to your bypass. If there is no transponder in the vehicle, the transponder bypass control harness is not needed.
-------------
Lectric Guy
Posted By: Mike M2
Date Posted: December 22, 2011 at 7:59 PM
There is no immobilizer in that car unless it has a V6 motor.
-------------
Mike M2
Tech Manager
CS Dealer Services
Posted By: oleg4
Date Posted: January 10, 2012 at 9:12 AM
|