1992 mx3
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129853
Printed Date: May 07, 2025 at 9:16 PM
Topic: 1992 mx3
Posted By: mario9272
Subject: 1992 mx3
Date Posted: December 26, 2011 at 1:26 AM
My Buddy and i are installing an auto start/ alarm in his mx3 had we have everything hooked up and the only problem we are having is inorder for the auto start to work we have to push the clutch in. He has look all over and can not find the switch on his car. any ideas?
Replies:
Posted By: howie ll
Date Posted: December 26, 2011 at 2:14 AM
Got to be there, try using a light and looking at the top of the metal piece attached to the pedal.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: mario9272
Date Posted: December 26, 2011 at 2:47 AM
We found the wire and now it works.Thank you
Posted By: scghost64
Date Posted: December 26, 2011 at 3:04 AM
I'm the guy that can't get the thing to work properly. Basically i found the two wire that make-up the safety switch. i made sure that these wires were the proper one's, by disconnecting them, pushing the clutch and see if it turns over, which it didn't. i grab the bypass wire from the module and connect it to the first wire; nothing. tried the second wire and nothing again. grabing a wire i bridged it, (fooling that the clutch is pressed), bingo! it worked. Started it the remove, but it turned off after three seconds, why?
Posted By: scghost64
Date Posted: December 26, 2011 at 3:05 AM
Started with the remote...
Posted By: howie ll
Date Posted: December 26, 2011 at 3:32 AM
Whoa there! You've connected a low current by-pass wire, assuming that's your word for status output or GWR to a wire without testing!
Great do you know the circuitry on this switch?
These are the possibilities.
Neg feed makes the circuit.
12v+ Ignition feed makes the circuit.
12v+ Starter feed makes the circuit.
You MUST TEST before connecting. You might just have cooked the R/S brain.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|