remote start, 2002 gmc envoy
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129860
Printed Date: May 04, 2024 at 11:56 AM
Topic: remote start, 2002 gmc envoy
Posted By: nlaw
Subject: remote start, 2002 gmc envoy
Date Posted: December 26, 2011 at 1:18 PM
i am hooking up a cheetah rs160 remote star and a gmdl-bp bypass on a 2002 gmc envoy, the locks won't lock or unlock, the r/s will click and the horn will churp and every thing else does what it should but won't crank. i am stuck!!!!
Replies:
Posted By: armbruster
Date Posted: December 26, 2011 at 10:44 PM
Need more information. The GMDLDP should do it all for you unless you have something hooked up incorrectly or have a faulty unit. Check the lock/unlock wires from your RS unit to make sure they are sending negative pulses to the bypass.
Posted By: nlaw
Date Posted: December 27, 2011 at 12:31 AM
ok, thanks, had local installer look at it and he thought it was that the disarm alarm wasn't hooked up, but the bypass should take care of that. CONFUSED!!!! THANKS FOR YOUR HELP
Posted By: nlaw
Date Posted: December 27, 2011 at 11:41 AM
getting -.003 on both lock and unlock
Posted By: jseibold
Date Posted: December 27, 2011 at 8:52 PM
The GMDLBP: I have used this module twice recently an each one did work, but I did have issues gettting it programmed to the correct vehicle platform until I read the important note on the programming instructions below. Your vehicle is platform 1 so if the module is new it should already be on platform 1. Did the LED on your GMDLBP react as per the programming instructions when you programmed it to the vehicle? And here is that important note in the instructions.....
IMPORTANT: DO NOT CONNECT VIOLET DATA OUTPUT WIRE OF INTERFACE MODULE TO VEHICLE DATA WIRE (PIN 2) UNTIL EVERY OTHER WIRE HAS BEEN CONNECTED & THE HARNESS HAS BEEN PLUGGED INTO THE INTERFACE (DL) MODULE. -------------
Posted By: nlaw
Date Posted: December 27, 2011 at 10:16 PM
the LED would flash once, but would not stay on like it was susposed to. it flashes once when i plug it in, then hold it down it flashes rapidly then 1 time and thats all i can get it to do. i did have the purple wire hooked up before finished, did that mess everything up? thanks for info, its been driving me crazy
|