ford f150 remote start not working
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129976
Printed Date: May 16, 2024 at 8:28 PM
Topic: ford f150 remote start not working
Posted By: blkrhyno
Subject: ford f150 remote start not working
Date Posted: January 01, 2012 at 9:28 AM
The vehicle is a 06 ford f150, installed a prestige 977A with a PKALL bypass everything works except the remote start. The bypass is programmed according to instructions, it starts with the key in the ignition test but thats about it, the tach is programmed, did it diagnostic test and got 2 flashes on the park lights which according to the instructions is a low tach signal, i have the tach wire connected at the uncommon wire @ coil. The software on the bypass is 4.06, whatelse should I try ?
-------------
Protect what's yours.
Replies:
Posted By: metz35
Date Posted: January 01, 2012 at 9:35 AM
See if it start when set to tachless
Make sure rx and tx aren't reversed
Make sure starters not bad unlikely
Make sure ground is solid
Make sure the bypass is comming on during start sequence
Posted By: blkrhyno
Date Posted: January 01, 2012 at 9:56 AM
Lol, you know I'm so use to always connecting the tach wire I sometimes forget about those other options. I triple check those rx and tx wires also. The light on the bypass is always on.
-------------
Protect what's yours.
|