viper 5301 remote start 9 flashes diag
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130087
Printed Date: July 12, 2025 at 10:39 AM
Topic: viper 5301 remote start 9 flashes diag
Posted By: flabbycat
Subject: viper 5301 remote start 9 flashes diag
Date Posted: January 06, 2012 at 9:46 PM
installing a 5301 in a 2002 grand caravan. when starting with the remote, every thing in the car turns on, but the engine does not crank. I am getting no power out of the violet wire(H3 pin 4) when I do the diagnostics I get 9 flashes for low battery (voltage model) have both reds to 12v hot, hood swith is ok, neutral safety switch plugged in and in the on position, H1 pin 5 black and H2 pin 18 BLACK/ white are grounded.
Replies:
Posted By: offroadzj
Date Posted: January 06, 2012 at 11:01 PM
Where do you have it grounded and where did you get your 12v constant from? Also check and make sure you aren't getting any input on the brake wire when the ignition comes on.
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
Posted By: howie ll
Date Posted: January 07, 2012 at 2:12 AM
Use a DMM to check the voltage between all your hot wires and the ground.
Have you powered up all the fused wires?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: January 07, 2012 at 2:16 AM
Both reds? Thin red, thick red and thick RED / white and RED / black.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: flabbycat
Date Posted: January 07, 2012 at 8:08 AM
my stupidity. turn page and read all connections. missed the r/b wire to power. thanks for your help
|