DEI relay question

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13031
Printed Date: June 08, 2025 at 11:53 AM

Topic: DEI relay question

Posted By: ksachet
Subject: DEI relay question
Date Posted: May 01, 2003 at 2:36 PM

Can someone help me figure out where the Domelight supervison wire is and how to hookup this relay. I have found the (+) 12v white wire, which I believe is to be the domelight supervison polarity wire (+) input but where is the Domelight supervison wire? Do you tie these wires together? Are they the same wire? if not where is the domelight supervision wire ? I have looked at several schematics , nothing listing a supervison wire and a (+) polarity supervison wire. I have a 98 pontiac sunfire. with a DEI python 460hP alarm. Help is greatly appreciated!

Replies:

Posted By: auex
Date Posted: May 01, 2003 at 5:16 PM

Ok here is what you need to do. First find the drivers side door trigger, it should be GREEN/ black in the dside kick panel. Then wire a relay: 85 12V+, 86 BLACK/ white supervision output, 30 ground, 87 output to door trigger. It is important that you use the actual door trigger and not the wire going to the light.

-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Print Page | Close Window