Print Page | Close Window

dei 1100x bypass wiring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130404
Printed Date: May 14, 2025 at 10:56 PM


Topic: dei 1100x bypass wiring

Posted By: pa_probe
Subject: dei 1100x bypass wiring
Date Posted: January 27, 2012 at 1:29 PM

I am wiring in a Directed 1100X bypass in Mode 2 for my 2004 Toyota Sequoia. The wiring diagram is pretty clear on all of the wires for IMO, IMI, power, ground and ground when running except the Orange-Ignition Input wire on the 9 pin harness. It does not state whether this should be a Neg or Pos signal wire. There is already a ground-when-running wire (blue/white wire) that goes to teh remote starter on the 3 pin harness.   So does this wire get connected to a 12v Accessory wire or something else? I believe this is the same as the 1100F and 1100GM.




Replies:

Posted By: metz35
Date Posted: January 27, 2012 at 2:19 PM
+ positive ignition . not accessory


Print Page | Close Window