2007 mdx, remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130574
Printed Date: May 20, 2024 at 9:33 PM
Topic: 2007 mdx, remote start
Posted By: tnosovit
Subject: 2007 mdx, remote start
Date Posted: February 10, 2012 at 12:39 PM
I'm going to install a clifford 20.7 (same as viper 5501) and an ADS-AL module into an 07 MDX. I have the wiring diagrams for the H3 harness.
my question is: what additional wires will i have to connect?
I know i'll have to do the parking break and parking light wires, but do i need to connect the +12 and ground off the H1 harness? also, other than the 3 data leads from the idatalink, do i need to connect any other wires?
Replies:
Posted By: tedmond
Date Posted: February 10, 2012 at 1:35 PM
constant 12v, acc, ign, start, parking lights, no need for parking brakes. everything else the idatalink link will take care of.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: tnosovit
Date Posted: February 10, 2012 at 2:15 PM
cool thanks.
ground too, right?
Posted By: tedmond
Date Posted: February 10, 2012 at 2:20 PM
that's correct.
are you sure the ads-al has been flashed specifically for your vehicle?
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: tnosovit
Date Posted: February 10, 2012 at 2:41 PM
i hope so. supposedly it was flashed with DBI-AL(DL)-HA
|