2000 tahoe ignition kill switch

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13059
Printed Date: June 07, 2025 at 2:36 AM

Topic: 2000 tahoe ignition kill switch

Posted By: callahan00
Subject: 2000 tahoe ignition kill switch
Date Posted: May 02, 2003 at 7:38 AM

I would like to install an ignition kill switch on my 2000 chevrolet tahoe. I've installed many on distributor type motors but this 5.3 motor is another story. Where would be the best/easiest place to wire in the switch for the ignition cut-off or would would it be better to wire in to the fuel pump circut to disable that. Thank you.

-------------
nova66

Replies:

Posted By: draasch
Date Posted: May 02, 2003 at 7:13 PM

i would do the ign. wire. if the system fails, you can start the truck. if you go the other way and it fails and you happen to be pulling out in traffic, you could BOOM! and have an accident.

you can buy just the starter disable for a few bucks. they have some that use a type of key that you insert in order to start the truck. it even has a red light on it.

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: draasch
Date Posted: May 02, 2003 at 7:18 PM

you might have a factory one in there already....

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: callahan00
Date Posted: May 05, 2003 at 7:06 PM

Thank you for the response, I went with the crank circut and installed a hidden toggle in series.. No problems so far. thanks again..

-------------
nova66

Print Page | Close Window