Print Page | Close Window

pkall programming 2000 toyota avalon

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130615
Printed Date: May 28, 2024 at 4:19 PM


Topic: pkall programming 2000 toyota avalon

Posted By: kog506
Subject: pkall programming 2000 toyota avalon
Date Posted: February 14, 2012 at 11:08 PM

I am confused on the PKALL connection and the programming.

For the connection, I am going to use D2D installation to the RS, Do I need to use any other wires? To program (Pr.2,Page 14) it says that I have to connect the D2D then connect the Connector 2. But Pg. 1 only show that I only need the D2D and (con.8 page 7) shows that I need the connect the RELAY wire (4 pin) if I an using Hard wiring. Can someone clarify this for me. PKALL Manual

And I have the PKALL and XK01 which modules should I program/connect first? and I should connect the RS wirings before programming any of the modules?



Replies:

Posted By: tedmond
Date Posted: February 14, 2012 at 11:29 PM
the 4 pin relay and the 6pin need to be connected to the vehicle.
the d2d cable is just for power/ground/gwr.

i would just that off that jst use RED / black for power and the blue/white on the 6pin for status


-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert


Print Page | Close Window