2006 volvo s80
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130667
Printed Date: May 11, 2025 at 3:44 PM
Topic: 2006 volvo s80
Posted By: cmk0808ny
Subject: 2006 volvo s80
Date Posted: February 19, 2012 at 10:15 AM
Do you need to power the key sense wire on this car for remote start? I see some sheets say yes and some say its not needed.
Also has anyone installed on this car and tripped an SRS light? I see that is also a common item on Volvo.
thanks
Replies:
Posted By: offroadzj
Date Posted: February 19, 2012 at 5:52 PM
I have not done one myself, but DEI wiring says that it is required... and so far I've had pretty good luck with the DEI wiring being correct. But again, I can't say for 100% certainty.
As far as the SRS light, the only time I've ever set one off myself was if the ignition was powered up with ANY airbag component connector unplugged. As long as I was careful and made sure to never power up the ignition with any connectors unplugged, then I never had a problem. But again, I can't say anything for sure on that specific vehicle.
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
Posted By: tianot
Date Posted: February 19, 2012 at 6:26 PM
keysense need to power up, the vehicle keysense is an output so must use a relay
-------------
tianot
Posted By: cmk0808ny
Date Posted: February 20, 2012 at 9:28 AM
how is the key sense an output? Keysense is an input to see when the key is inserted into the cylinder. I can power it with a gar and relay but I want to make sure I am understanding properly.
Posted By: tianot
Date Posted: February 20, 2012 at 6:58 PM
your keysense wire is an output. use a relay, 86&87 to 12v, 30 to keysense, 85 to gwr.
-------------
tianot
Posted By: offroadzj
Date Posted: February 20, 2012 at 9:49 PM
And regardless of input / output, it is a + signal so you still need a relay to convert the - GWR output of the alarm to a + signal.
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
|