2011 jeep wrangler evo chr issue
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130729
Printed Date: May 15, 2024 at 12:29 PM
Topic: 2011 jeep wrangler evo chr issue
Posted By: DannyNY
Subject: 2011 jeep wrangler evo chr issue
Date Posted: February 24, 2012 at 1:01 PM
Hi all,
Been awhile since I posted.. hope someone can help.
I have a 2011 Jeep Wrangler 2dr.. I just installed a Chrimestopper RS7 G3 with the Fortin EVO-CHR with the Datalink. Install was a breeze, much better then when I installed a RS on my Trailblazer back in 04 UGH! OK, the problems are.. when I take over with the key, the low tire warning light goes on and then off after its displayed... I can live with that. The other problem is i don't wanna live with, the fuel gauge is stuck. Just filled it up and still reads between half and three quarters. It was working fine before the install. Other then those 2 issues, I have no other problems. It starts, runs, doors lock and unlock from the CS fob. Just wondering if anyone heard of these issues on a Wrangler or any other car or truck.
Thanks for any info on this..
Danny
Replies:
Posted By: tedmond
Date Posted: February 24, 2012 at 4:31 PM
check to see if it is a bypass issues. disconnect the remote start entirely, if everything works as it should, start troubleshooting form that point on.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
|