how to remove transmitter from audiovox?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130818
Printed Date: July 17, 2025 at 9:19 PM
Topic: how to remove transmitter from audiovox?
Posted By: legenux
Subject: how to remove transmitter from audiovox?
Date Posted: March 05, 2012 at 11:44 AM
Hello all,
I was successful in programming an old transmitter to use on the new alarm (APS901) remote starter. However, it seems now the same transmitter will remote start two vehicles at the same time (old car, new car when they are together.)
Is there a away to remove the transmitter from the old car completely? I followed the instructions below. Thanks.
To program this transmitter into your remote start upgrade
unit:
1) Turn the ignition to the on position
2) Press and release the programming switch 3 times
3) Press and hold, for 3 seconds, the button of the
transmitter you wish to add until the parking light
flashes indicating the transmitter has been learned.
4) Repeat step 3 for each transmitter up to a total of 4.
Turn the ignition off to exit the program mode
Replies:
Posted By: Mike M2
Date Posted: March 05, 2012 at 4:04 PM
Learning the remote 4 times in a row will delete any old codes. Follow the above instructions 3 more times and you should be good...
-------------
Mike M2
Tech Manager
CS Dealer Services
Posted By: legenux
Date Posted: March 05, 2012 at 4:11 PM
Thank you Mike again.
|