motion sensor add on
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130878
Printed Date: May 19, 2024 at 2:31 AM
Topic: motion sensor add on
Posted By: 123-300zx
Subject: motion sensor add on
Date Posted: March 11, 2012 at 3:58 PM
i have a viper 5501 responder .I have purchased a dei dual zone motion sensor to add to the responder .How do I get the responder to notify me when the motion sensor is triggered.I thought this dual zone sensor would plug directly into the 5501 but it does not.need some ideas and they would be greatly appreciated
Replies:
Posted By: h2oskierfl
Date Posted: April 07, 2012 at 2:58 PM
If the alarm has an external shock sensor, you can splice in to the same plug. Wire colors will be the same. Red and black are positive and ground. Green and blue are the two stages of sensor.(warn away and full trigger) If the Shock sensor is internal, use another sensor wire that is not currently in use (e.g. positive door trigger, dome light supervision, etc.) you may need a relay or two to get the polarity right.
Posted By: howie ll
Date Posted: April 07, 2012 at 6:47 PM
Dome supervision isn't a sensor wire.
The safest way is join blue and green then connect to the 5501 blue.
If that's being used remember to diode separate them which should be in your 508d instructions.
It will now show as either hood or trunk sensor.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|