Print Page | Close Window

compustar cs600s

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=131107
Printed Date: May 02, 2024 at 8:28 AM


Topic: compustar cs600s

Posted By: TooDark
Subject: compustar cs600s
Date Posted: April 02, 2012 at 7:44 PM

Has anyone had any luck with the tachless setting? It does not seem to be working on the 2008 250 diesel I installed it into yesterday. Truck starts and stays running for 4-6 seconds then shuts down and does this 3 times then done.



Replies:

Posted By: Chris Luongo
Date Posted: April 02, 2012 at 10:11 PM
I've only installed just a few of those entry-level Compustar units, and don't plan to ever again.

I'm under the impression that the tachless setting on those things doesn't work. At least the one car I did tachless, a 2006 Pacifica, turned into a multi-comeback headache. It works just well enough to let you think everything's OK and send the customer on his way, and then fails the next day.

The Pacifica I was working on would remote start and run just fine, but then after about 3 seconds, the unit would turn off, try again....and then after two more tries stop completely. And there's no provision to adjust the voltage sensitivity or anything like that, either.

So I think you're probably going to have to hook up tach.





Print Page | Close Window