dei 529t
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=131826
Printed Date: July 15, 2025 at 1:25 AM
Topic: dei 529t
Posted By: specvay
Subject: dei 529t
Date Posted: July 15, 2012 at 2:14 PM
just wanted to say hi and thanks for any help in advance!
i got a 02 nissan sentra spec v. im trying to install the 529t to operate my sunroof. only issue im having is that it just pulse little by little when i try to activate it with the remote to open with my 3303 remote. also when i arm the system it also pulse to close..ive been trying to figureout how to get a full negative signal instead of small pulse but i dont know how, been going at this for a few days now....hopefully i can solve this issue.
also .ive done the 530 to both my front window....and i know that the 530 have adjustable resistance.....but the 529 dont......im completely lost
-------------
Specvay
Replies:
Posted By: howie ll
Date Posted: July 15, 2012 at 4:10 PM
To close are you using the same output (GWA) you used with the 530t but diode separated?
To open it will only move for as long as you hold the button and then it will take 1.5 seconds before responding.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: specvay
Date Posted: July 15, 2012 at 4:27 PM
yes im using the same ground to arm as i did with my 530t....all i did was spice it in with my orange 530t wire harness...
i did hold the aux button, all i get is a pulse and a crack of the sunroof......
i still have the gray and gray/black wire i didnt use....im so lost
-------------
Specvay
Posted By: howie ll
Date Posted: July 15, 2012 at 4:36 PM
Look in the instruction manual, the section that says combine both modes, it might be your answer.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: specvay
Date Posted: July 15, 2012 at 10:11 PM
i will look for it in the 529 instruction manual, i dont recall seeing anything like that but i will look at it again tomorrow....
this is definity making me so mad....
-------------
Specvay
Posted By: howie ll
Date Posted: July 16, 2012 at 12:14 AM
Seen my signature line, the part where it says read the manual?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: specvay
Date Posted: July 16, 2012 at 5:07 PM
ive read the instruction completely i have it setup correctly....i thinking i need the pulse generator by dei....anyone else got input or ideas? please help thanks!
-------------
Specvay
Posted By: howie ll
Date Posted: July 16, 2012 at 5:10 PM
Have you gone to the motor wires?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: specvay
Date Posted: July 16, 2012 at 5:49 PM
i can only go to the motor becuz the sunroof switch only work with ignition on.....
im assuming i need the dei 528t pulse generator...... or mayb buy another 530t instead of using the 529t.
im completely lost
-------------
Specvay
Posted By: howie ll
Date Posted: July 16, 2012 at 5:59 PM
The switch isn't relevant, you're getting power through the 529t red wire.
This is similar:- B3E_honda_roof_ii.bmp------------- Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: soundnsecurity
Date Posted: July 16, 2012 at 6:14 PM
how many devices do you have powering through your ground when armed? also did you ground the modules to the ground when armed too? ive actually never installed a window module but i know when something sound like its overloaded because each module is being activated at the same and the GWA only supplies a limited amount of current. try hooking your GWA up to activate a relay and send a true ground through the relay to activate your window modules.
-------------
Posted By: specvay
Date Posted: July 16, 2012 at 6:46 PM
yea i will have to try a relay to see if i can get a true ground to the sunroof motor....
ive only got 2 GWA spice in, my 530t and my 529t
-------------
Specvay
|
