Print Page | Close Window

code alarm/ remots

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13189
Printed Date: August 22, 2025 at 2:04 AM


Topic: code alarm/ remots

Posted By: hardyc
Subject: code alarm/ remots
Date Posted: May 05, 2003 at 4:34 PM

Ok I have a code alarm sys1100 it has been unused for the last year today i hook it back up and my remote is not working. its not the battary.  is they a way to marry the remot  to the alarm ?

thanks




Replies:

Posted By: NowYaKnow
Date Posted: May 05, 2003 at 8:45 PM
First let me say I'm not familiar with the particular system you have. Most of the time with code alarm you open the door, put the key in the ignition and turn the ignition on, then find the push button switch and hold that for 10 - 15 seconds until the horn/siren goes 3 times. Release the button and hit a button on the remote to program it. What button? it changes just hit them one at a time until the units responds..If that doesn't work do the same thing except after 10 - 15 seconds after it beeps don't release the button hold it in the whole time and program the remote. Like I said I'm not familiar with that system this is just a general programming procedure most code alarms use.




Print Page | Close Window