Print Page | Close Window

06 chrysler 300

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=131962
Printed Date: March 28, 2024 at 7:14 AM


Topic: 06 chrysler 300

Posted By: ziggyb222
Subject: 06 chrysler 300
Date Posted: August 05, 2012 at 9:17 PM

I have a Evo-Chr and a T-harness for the non tip start. Trying to pre-wire everything but need to know if this car has a positive start wire.... Anyone???? Thanks in Advance!!!



Replies:

Posted By: kreg357
Date Posted: August 05, 2012 at 9:33 PM

Locate and test this wire ( listed by DEI, ADS & Audiovox )  :
Starter        Pink/Dark Green (+)         @ ignition switch, Black 5 pin plug, Pin 4

Should also have PURPLE / Brown MUX wire.



-------------
Soldering is fun!




Posted By: auto enhancers
Date Posted: August 05, 2012 at 10:54 PM
I haven't used any Fortin modules for a few years but why would that matter if you are using acT harness?
Second you should pull the panels of the dash prior instillation so you know where you will need to route your wires. Also TEST them prior to installation.




Posted By: jmsounds
Date Posted: August 06, 2012 at 1:55 PM
it all depends on what type of key you have if is blade type you can use the starer wire and also you need to use the ignition wire as well
evochr works great if you have any problems call tech support they will walk you thru it never have any problem with this modules




Posted By: ziggyb222
Date Posted: August 07, 2012 at 5:38 AM
If it is a positive start wire a extra relay is needed on that wire.. Was just pre-planning the install.. I test all wires.. Thanks





Print Page | Close Window