viper 5704 , glass break 506t

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=131990
Printed Date: May 04, 2024 at 6:07 AM

Topic: viper 5704 , glass break 506t

Posted By: uf-engineer
Subject: viper 5704 , glass break 506t
Date Posted: August 10, 2012 at 7:41 PM

I recently finish installing a 5704 and 506T glass break sensor. The sensor came with a why harness. The manual says that the DEI shock sensor reports as zone 2 while the 506T, glass break, reports on zone 4. The 5704 manual says that you need the bitwriter (which I don't have) to program zone 4 to a glass break sensor. Do I need to program zone 4 for the glass break sensor to work. What is this option in the bitwriter programming for?

Also, I'm not sure if the glass break sensor is working. How do I test it.

Thanks

Replies:

Posted By: vutekho
Date Posted: August 14, 2012 at 10:24 AM

No, you shouldn't need to program it with a Bitwriter to work.

Without the Bitwriter, you'll only see Zone 4 if the glass/breakage sensor triggers.

To test it, adjust the sensor, sit in the car, armed it, then shake your keys or whistle while inside the car, and you should see the red LED on the module blink and the alarm triggers instantly. Or close the door, arm it, and tap your window with key(s). The alarm should go off too.

Print Page | Close Window