viper 160xv

i have a viper 160XV system  that was taken out of the car before i bought it and i may think it that when the last owner took it out he may have cut wires he shouldnt have and i want to put it back in but dont know what wires go where does anyone have a wiring diagram for it to hook up to a 99 dodge avenger es v6

-------------
One Awesome 99 Avenger ES

DIRECTWIRE™ WIRING INFORMATION - DODGE / AVENGER / 1999 / Remote Start


[PRINT THIS PAGE]


12volts white + ignition harness
Starter BLACK/ red + ignition harness
Second Starter       
Ignition BLACK/ white + ignition harness
Second Ignition       
Third Ignition       
Accessory blue/black + ignition harness
Second Accessory       
Keysense       
Power Lock BROWN / white - driver kick, door harness
Power Unlock brown - driver kick, door harness
Notes: To unlock only the driver door on models with keyless entry, use BROWN / blue (-) at the relays behind the radio.
Lock Motor blue/black 5wi driver kick, door harness
Unlock Motor blue/red 5wi driver kick, door harness
Parking Lights+ GREEN / WHITE + driver kick, harness to rear
Parking Lights- GREEN / WHITE - headlight switch
Notes: Found in a gray 20-pin connector.
Hazards       
Turn Signal(L)       
Turn Signal(R)       
Reverse Light       
Door Trigger RED / green - driver kick, harness to rear
Notes: To avoid the dome light delay use RED / white (-) at the door open indicator at the instrument cluster. The RED / white will also catch the rear hatch.
Dome Supervision use door trigger wire     
Trunk/Hatch Pin RED / green - driver kick, harness to rear
Notes: To avoid the dome light delay use RED / white (-) at the door open indicator at the instrument cluster. The RED / white will also catch the rear hatch.
Hood Pin blue/black - fuse box
Trunk/Hatch Release       
Power Sliding Door       
Factory Alarm Arm GREEN/ YELLOW - driver kick, door harness
Notes: Meter this wire while turning the key in the driver door key cylinder.

Can also use the passenger door key cylinder which is RED / blue (-) in the passenger kick, door harness.
Factory Alarm Disarm GREEN / WHITE - driver kick, door harness
Notes: Meter this wire while turning the key in the driver door key cylinder.

Can also use the passenger door key cylinder which is BROWN / red (-) in the passenger kick, door harness.
Disarm No Unlock see factory alarm disarm     
Tachometer white ac instrument cluster or PCM
Notes: The PCM is located on the drivers side of the engine compartment or behind the center of the dash depending on motor.
Wait to start       
Brake Wire GREEN / WHITE + brake pedal switch
Parking Brake       
Horn Trigger GREEN/ black - horn switch
Memory Seat 1       
Memory Seat 2       
Memory Seat 3       
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.