python 991 integration with factory alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=132054
Printed Date: May 03, 2024 at 4:48 PM

Topic: python 991 integration with factory alarm

Posted By: sicivic13
Subject: python 991 integration with factory alarm
Date Posted: August 23, 2012 at 11:28 AM

I installed a Python 991 remote start alarm on my 2008 Honda Civic Si a few months back. I never integrated it with the factory alarm and am now interested in doing so. My question is do I simply tap into the OEM Arm and Disarm wires on the vehicle with the OEM Disarm and OEM arm wires from the Python 991? Or do I need relays in order to make this work?

Thanks.

Replies:

Posted By: racerjames76
Date Posted: August 24, 2012 at 8:43 AM

That sounds correct to me. I am familiar with the civic but not the alarm you speak of. If I remember correctly the factory alarm control wires on that car are behind the fuse block above the drivers kick panel in the harness coming from the drivers doorl. They are VERY tiny wires. I suggest being very cautious with a razor knife or you may try the old trick of holding a lighter on the wire for a split seconds then rubbing in a twisting motion with your thumb and pointer finger to break or crumble the insulation off of the wire. There are only a few strands of wire so BE CAREFUL! posted_image

-------------
To master and control electricity is perfection. *evil laugh*

Posted By: sicivic13
Date Posted: August 24, 2012 at 8:57 AM

Do I just connect the 991 wires to the OEM Disarm/Arm wires? I assume no relays are needed. Correct?